7
English
Protrusion
Pulley guard (B)
M8 bolt
Slide cover
Slide cover holder
Butterfly bolt
(5 mm)
Fig. 16
<Contour cutting work
(Fig. 17)
>
(1) Turn the lever switch on.
(2) Hold the workpiece with both hands. Slowly slide it on the
contour table to the band saw blade to cut its contours.
(3) Press the workpiece against the band saw blade by
exerting a load that is not excessive to the point where
it warps the blade. Exercise care not to apply excessive
loads to the blade.
NOTE
Turn the lever switch o
ff
each time you
fi
nish cutting
workpieces.
Workpiece
Band saw blade
Contour table
Lever switch
OFF
ON
Fig. 17
10. Moving the band saw installed on the band saw
stand
When moving the band saw installed on the band saw
stand, move the main unit down to the lower limit position
as shown in the
fi
gure below. Tighten the stopper bolt so
that the main unit does not move up, then hold both ends
of the base.
(Fig. 18-a)
The band saw stand has wheels, which enables you to
hold the front handle and lift the pulley guard (B) side to
move the band saw.
(Fig. 18-b)
NOTE
Remove the band saw blade and battery even when you
move or store the band saw installed on the band saw
stand.
Stopper bolt
Fig. 18-a
Stopper bolt
Wheel
Front handle
Fig. 18-b
00Book_Band Saw Stand.indb 7
00Book_Band Saw Stand.indb 7
2021/10/22 13:15:25
2021/10/22 13:15:25
