English
22
CUTTING PROCEDURES
1. Place the saw body (base) on the
lumber, and align the cutting with the
saw blade at the front scale (
Fig. 6
).
2. Turn ON the switch before the saw
blade contacts the lumber. When
you are going to turn ON the switch,
push the button on the side of handle
fi
rst to release OFF lock means, then
squeeze the switch trigger.
When you turn OFF the switch,
release the switch trigger.
CAUTION
Prior to cutting operation, make sure the material you are going to cut. If the
material to be cut is expected to generate harmful / toxic dusts, make sure the dust
bag or appropriate dust extraction system is connected with dust outlet tightly.
Wear the dust mask additionally, if available.
○
Before starting to saw, con
fi
rm that the saw blade has attained full-speed
revolution.
○
Should the saw blade be stopped or made an abnormal noise while operating,
promptly turn OFF the switch.
○
Always take care in preventing the power cord from coming near to the
revolving saw blade.
○
Using the Circular Saw with the saw blade facing upwards or sideways is very
hazardous. Such uncommon applications should be avoided.
○
When cutting material, always wear eye protection.
○
When
fi
nished a job, disconnect the plug from the receptacle.
MOUNTING AND DISMOUNTING THE SAW BLADE
CAUTION
To avoid serious accident, ensure that the switch is in the OFF position, and the
power source is disconnected.
1. Dismounting the saw blade
(1) Set the cutting volume at
maximum, and place the
Circular Saw as shown in
Fig. 7
.
(2) Depress the lock lever, lock
the spindle, and remove the
hexagonal-socket bolt with the
hex. bar wrench.
Lumber
Marking-o
ff
-line
Front scale at
45° incline
Front scale when
not inclined
Fig. 6
Hex. bar wrench
Hexagonal-socket bolt
Depress the lock lever
Tighten
Loosen
Fig. 7
000Book̲C7SS̲ChS.indb 22
000Book̲C7SS̲ChS.indb 22
2018/03/27 16:56:59
2018/03/27 16:56:59
