Step 4
Attach center post to ground stake
With the ground stake in place and the locking tabs set into
position slide Center post (B) over the stake as shown in Figure 4
below.
Note: Make sure to slide the post straight down so the locking
tabs touch the inside wall and properly engage in the corners of
the
highwood
®
post as shown in Figure 5 below.
Step 6
Step 5
Install metal ground stakes for end posts
Take each of the side sections (A) and hold them in the position
that they will be fitted to the center post. Double check and
carefully mark the end post (C) locations on the ground. Remove
side sections and install two ground stakes (F) for End posts (C)
following Steps 2, 3, and 4.
Fig. #4
Fig. #5
Fig. #6
Final post adjustment
Final adjustment may require you to twist the post and ground
stake so the three posts are positioned in the correct direction.
This rotation adjustment will not disrupt the ground attachment of
the stake.
Note: Ensure that the corner fence will be straight and in-line
when assembled.
