SuSE Linux 10.1 (Open and Novell) Driver Support
4 – Updating the Driver
To update the driver, simply reinstall the driver following the steps in previous
section, “ Install RocketRAID 152x Driver on an Existing System “.
Note: If the driver is loaded in initrd (when system is installed onto a disk or array
attached to the RocketRAID 152x), you need to run the mkinitrd command to update
the initrd file. If you are using the lilo boot loader, run lilo again (# lilo).
5 – Installing the RAID Management Software
HighPoint RAID Management Software is used to configure and keep track of your
hard disks and RAID arrays attached to RR152x controller. Installation of the manage-
ment software is optional but recommended. To configure HighPoint RAID Manage-
ment Software to work with RR152x driver, you should setup /etc/hptcfg to be the
driver name: # echo hpt37x2 > /etc/hptcfg Please refer to HighPoint RAID Manage-
ment Software documents for more information (updated versions are always avail-
able from the HighPoint website).
6 - Uninstalling the Driver
To uninstall the RocketRAID 152x driver
Note: The driver cannot be uninstalled while the system is booted from a disk or array
attached to the RocketRAID 152x.
To uninstall the driver, remove the lines added to /etc/modules.conf and /etc/fstab.
6-5
Summary of Contents for RocketRAID 152x Host Adapter
Page 58: ...Appendix Customer Support...
