Highlite International D3832, User Manual, Page: 16 / 24

15
WMS4T-B
Product code: D3832
Installing the Mounting Plate
Install the mounting plate (07) with the mounting hooks facing up (Fig. 14).
Fig. 14
To install the mounting plate (07) , follow the steps below:
Hold the mounting plate (07) , with the rubber gasket (08) , against the wall, in such a way that all
cables fit through the opening in the rubber gasket (08) (Fig. 15).
Note:
Make sure that the opening in the gasket is located at the bottom (Fig. 15). If, for any reason, such
installation is not possible, seal the opening with a waterproof sealant to protect the device from the
ingress of water (Fig. 16).
Fig. 15 Fig. 16
Insert and tighten the screws to install the mounting plate (07) and the rubber gasket (08) on the wall
(Fig. 17). The screws shall be at least 12,5 mm long. Do not overtighten the screws as this can
damage the
mounting plate (07) . The damaged mounting plate (07) cannot support the weight of
the device and can break easily.
Fig. 17