HighLine RCH Mower, Operator'S Manual

Page: 31 / 82

Section 3 - Mower Preparation
Page 3-8
13. Wing Adjustment Procedure
Note : Level the center section before adjusting wing height.
1) Fully raise the mower by extending the
lift cylinders. Hold the lever open for
30 seconds to ensure the phasing
cylinders are synchronized.
2) On a level surface, lower the mower to
the preferred cutting height.
3) On one wing, measure the height from
the top of the chain mount strap near
the center section (1) to level ground.
Compare the measurement to a
location on the outer wing section (2).
4) Loosen the wing height adjustment
jam nut (1).
- Adjust the height of the wing using the
adjustment nut (2).
- Use the Setup Factor #2 - Wing
Adjustment diagram (shown above)
for the heights.
- Measure and compare.
5) Tighten the jam nut (1).
6) Repeat the procedure on the other
wing.
Measure Wing Heights
107032C
Adjust Wing Height
108011C