High Power RockSolid Pro 1600W, User Manual, Page: 7 / 32

4
● If your PSU is equipped with the modular cable management, please refer to the
instruction sticker attached on the PSU for the proper cable set.
● Make sure all connectors are connected properly and firmly.
Protection function
To save guard the power supply and the system, the High Power PSU is built in
with comprehensive protection functions; Over Voltage Protection, Under Voltage
Protection/Over Current Protection, Short Circuit Protection, and Over Load protection/
Over Temperature Protection.
Note: The PSU will be shut down if the protect function is triggered. To restore the
PSU back to normal, please either switches off the I/O then on or unplugs the AC
power cord and plug it again then.
Trouble shooting
If your PC system does not respond, please make following checks:
1. Make sure the AC power cord is connected firmly and the AC power switch is
turned on.
2. Make sure all DC output connectors are connected in the right direction and
plugged firmly.
3. Check whether there is any short circuit problem or defective peripherals by
unplugging each peripheral device one at a time.
4. If one of the above mentioned problems occurs, please remove the fault and
wait for 1-2 minutes before you turn on the PSU again. This is necessary to
release the latch condition of the protection circuit.
5. If the PSU is still unable to power up after above checks, please contact with
your dealer for