Pull an extension servo wire through the
pre-drilled hole. Please use metal gear
servo’s. Don’t forget to set the servo horn in
its middle position with your transmitter
before you install the servo
Solder the servo wires to the extension cable
and isolate the wires with shrinktube.
If you use extension cords with male and
female ends you don’t have to do soldering.
Check the alignment of the hinges so that
they are exactly in the middle . Do this for
the elevon and the wing. Correct the pre-cut
slots if neccesary .
Than glue the hinges in the elevon and wing
with Thin CA glue
In stall the clevises and pushrods
Now install the controll horn on the elevon
Set the elevon 5-6mm up.
