Notice the 2 opposite z-bends, this is what you pushrod should look like.
Cut the slot with a dremel tool or a sharp knife. At the marked location see above
picture.
Take out the plywood control horn; secure the servo to the servo bracket. Cut the
servo horn so that only the hole nearest to the servo middle stays on. Now insert the
Z-bend in the servo horn and install the servo horn on the servo. Run the pushrod out
of the fuselage as shown in the top right picture.
You should now add the supplied Washer to act as a spacer between the
elevon and fuselage.)
Now insert the z-bend in the plywood control horn. Glue the horn in the Elevon with
thin CA glue or 5 minute epoxy Now do the other elevon the same way.
The Gap over the servo bracket can be covered with white vinyl decal or a piece of
white iron on covering.
Summary of Contents for F16
Page 17: ......
