High End Systems studio color, User Manual

Page: 73 / 114

Appendix A Troubleshooting and Maintenance A-5
Introduction
T
roublesho
oting
an
d Ma
inten
ance
A
P A N D R V
E R R
pan driver error • motor wire shorted to
ground
• driver chip bad
• bad motor
• refer to qualified
service personnel
P A N
C O N N
pan connector is
disconnected • pan connector is dis-
connected
at the logic
board or at the sensor
• refer to qualified
service personnel
P A N
E N C D
pan encoder failure • external obstruction
• bad connector
• remove obstruction
• refer to qualified
service personnel
P A N E R R
pan homing error • loose pinion gear
• loose motor cable
• incorrect cabling to
pan input
• bad sensor
• bad motor
• run self-test and
refer to qualified
service personnel
P R G M
T I M E
program time has
expired during an
upload • bad board • refer to qualified
service personnel
S V C C
E R R
sensor power error • bad board
• loose cable
• refer to qualified
service personnel
S E N S
T O U T
sensor time-out • fixture attempted to
correct pan/tilt posi-
tion without success
due to a physical
obstruction
• bad sensor 1 or 2
• remove the
obstruction and
reset the fixture
• refer to qualified
service personnel
Table A.1:Display Error Messages
Display
Message
Problem Explanation Solution