High End Systems studio color, User Manual

Page: 72 / 114

A-4 Studio Color User’s Manual
L A M P
O U T E R R
lamp has extin-
guished during
operation • dead lamp
• power supply failure
• replace lamp, refer
to "Replacing the
Lamp" on page A-
11
• refer to qualified
service personnel
L A M P
T O U T
E R R
lamp time-out error • lamp too hot to
restrike
• dead lamp
• ignitor error
• allow time for the
lamp to cool, and
home the fixture to
restrike the lamp
• replace lamp, refer
to "Replacing the
Lamp" on page A-
11
• refer to qualified
service personnel
L I N K
B U S Y
other data present
on the link during a
cross load • controller is still con-
nected to the link • disconnect control-
ler
L I N K
E R R
link error • bad cable(s)
• no data
• bad data
• output from previous
fixture is bad
• bad comm board
• test and replace
cable(s) as neces-
sary
• test data line
• test data line
• test by bypassing
previous fixture
• refer to qualified
service personnel
O V E R
value counter is out
of range • lamp strikes, lamp
hours, or fixture hours
have rolled over 9999 • reset the out of
range item
O V E R
T E M P
fixture is over tem-
perature • temperature is too
high • fixture is too close
to a major heat
source
• check and reduce
ambient tempera-
ture
Table A.1:Display Error Messages
Display
Message
Problem Explanation Solution