High End Systems studio color, User Manual

Page: 33 / 114

Chapter 1 Installation and Setup 1-7
Introduction
Inst
allation and Set
up
1
Lamp Installation
You will need the following items to install or replace the lamp:
•
¼ inch hex wrench
• Philips MSR 575/2, MSD 575, or factory approved lamp
• Protective gloves
• Protective goggles
Note: do not mix lamp types! The MSR 575/2 and the MSD 575 have different color
temperatures and characteristics.
To install or replace the lamp, complete the following procedure:
1. Remove power from fixture. If the fixture has been in operation, allow it to
cool for at least five minutes before continuing.
2. Using the ¼-inch hex wrench, loosen the hex screws located at the rear of the
fixture and remove the lamp access cover. Refer to Figure 1.5.
Figure 1.5. Removing the Lamp Access Cap
3. Holding the lamp by its base, align the lamp leads to their female slots and
carefully push the lamp into the socket. Refer to Figure 1.6.
Warning: Do not touch the lamp with bare fingers. If the lamp is accidentally
touched, clean it immediately with a soft cloth and isopropyl alcohol
(C
3
H
8
O). An alcohol cloth is provided with each lamp.
S
tudio
C
ol
or