24
ENGLISH
LINE INPUT
Connect the LINE INPUT RCA jacks with the head unit by using appropriate audio signal cables.
6
HIGH LEVEL INPUT
If your head unit does not have RCA preamp outputs, you can use the HIGH LEVEL INPUT. Connect
the loudspeaker cables of the head unit to the included cable harness.
8
LINE OUTPUT
The LINE OUTPUT RCA jacks provide a linear full-range audio signal for driving additional amplifiers,
such as the ZXR1200/1 monoblock.
7
AUTO TURN-ON
If your head unit does not have a turn-on signal (REM), you can use the automatic turn-on function of
the amplifier. This works in two ways, which can be set at the AUTO TURN-ON switch:
DC
: This method only works if you use the amplifier’s
HIGH LEVEL INPUT
. The amplifier then detects
a voltage rise to 6 volts when the head unit is turned on by a so-called “DC offset” and then turns on
the amplifier.
VOX
: Select this method when using the
LINE INPUT
RCA jacks. The amplifier then detects a voltage
increase in the incoming audio signal when switching on the head unit via the attached RCA cable and
then switches on the amplifier.
Note:
As soon as the head unit is switched off again, the amplifier switches itself off.
The terminal for the amplifier turn-on can now be used to supply additional amplifiers with a turn-on
signal. Simply connect the REM terminals of the two amplifiers and make sure that the other amplifier
is in “normal” turn-on mode, which means that the
AUTO TURN ON
function is disabled.
9
DESCRIPTION OF OPERATION
SPEAKER
OUTPUT
LINE OUTPUT
LINE INPUT
L
R
L
R
HIGH LEVEL INPUT
LEVEL
MIN
MAX
HIGH PASS
10 Hz 500 Hz
LOW PASS
50 Hz 5 kHz
BASS BOOST
0 dB 12 dB
DC VOX OFF
AUTO TURN-ON
FULL HP LP/BP
REMOTE
BLC
POWER
PROTECT
POWER INPUT
GND
+12V
REM
IN/OUT
BP
X-OVER MODE
BRIDGED
L
R
ZXR 600/2
6
7
8
9 10 11
12
14 15 16
13
