25
26
21
SPECIFICATIONS
|ENG
MODEL
CHANNELS
CIRCUIT
OUTPUT POWER RMS 13,8 V
Watts @ 4 Ohms
Watts @ 2 Ohms
Watts @ 4 Ohms mono bridged
OUTPUT POWER MAX. 13,8 V
Watts @ 4 Ohms
Watts @ 2 Ohms
Watts @ 4 Ohms mono bridged
Frequency Range –3dB
Damping Factor
Signal-to-Noise Ratio
Channel Separation
THD&N
Input Sensitivity
Input Impedance
X-Over Modes
Various Highpassfilter
Various Lowpassfilter
Bass Boost @ 50 Hz
Bass Remote
Line Outputs RCA
Fuse Ratings
Dimensions
Width x Height x Length
TSi400-II
2
CLASS A/B Analog
2 x 100
2 x 175
1 x 350
2 x 200
2 x 350
1 x 700
20Hz - 30 kHz
> 400
> 90 dB
> 60 dB
0,05%
6 - 0.2 V
> 47 kOhm
LPF/BPF - HPF - Full
10 - 1200 Hz
30 - 150 Hz
0 - 12 dB
BLC-TSi
Fullrange
2 x 20 A
220 x 55 x 250/315 mm
Technical specifications are subject to change!
Errors are reserved!
For damages on the vehicle and the device, caused
by handling errors of the device, we can’t assume
liability.
All HiFonics Amplifiers are tagged with a individual
serialnumber, which will be registerd for statistic
and service conditional purposes.
All HiFonics Amplifiers are tagged with a CE-
Certification Mark. Thereby these devices are
ceritified for a use inside vehicles inside the
European Union (EU).
WARRANTY DISCLAIMER
The limited warranty comply with legal regulations.
Failures or damages caused by overload, improper
use or by using the product for competitions are
not covered by the warranty.
Please return the defective product only with a
valid proof of purchase and a detailed malfunction
description.
TSI600-II
2
CLASS A/B Analog
2 x 150
2 x 275
1 x 550
2 x 300
2 x 550
1 x 1100
20Hz - 30 kHz
> 400
> 90 dB
> 60 dB
0,05%
6 - 0.2 V
> 47 kOhm
LPF/BPF - HPF - Full
10 - 1200 Hz
30 - 150 Hz
0 - 12 dB
BLC-TSi
Fullrange
4 x 15 A
220 x 55 x 300/365 mm
You can simplify the installation of the high level speaker connections, if you use the separately available hi-to-lo adaptors
HF-HLA from HiFonics. You may find the adaptor at your car audio retailer.
With the HF-HLA you just need to connect the bared speaker cables in the regarding ports and connect the RCA jacks with LINE IN on
the amplifier.
Please ensure the correct polarity of the connections.
Usually the ”+” positive cables are red or dark grey,
With one HF-HLA adaptor you are able to connect one channel pair,
this means for a 2-channel amplfier you need one adaptor.
OPTIONAL ACCESSORIES FOR HiFONICS TITAN TSi AMPLIFIERS
R
Speaker Cables
+
To the LINE IN on the Amp
–
–
+
L
