Hifonics PLUTO IV, User Manual

Page: 20 / 32

20
ENGLISH
ELECTRICAL INTERCONNECTION
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufficient profile section (refer to the table on the next page) and a suitable fuse rating and the conductivity
of the cables when you purchase your wiring kit. Clean and remove rust-streaked and oxidized areas on the
contact points of the battery and the ground connection. Make sure that all screws are fixed tight after the instal-
lation, because loose connections cause malfunctions, insufficient power supply or interferences.
REM
IN
RL–
INPUT
POWER
PROTECT
RL+
INPUT
FL–
INPUT
FL+
INPUT
FR–
INPUT
FR+
INPUT
RR–
INPUT
RR+
INPUT
R–
R+ FL–
FL+ FR–
LOW LEVEL INPUT OUTPUT REM
FRONT REAR
HIGH LEVEL
INPUT
SPEAKER
OUTPUT
LIMITED
POWER INPUT
FULL POWER INPUT
FR+
RL–
RL+
GND
+12V
GND
+12V
RR–
RR+ RL–
RL+
FR–
FR+ FL–
FL+
RR–
RR+ L–
L+
REM
OUT
HPF LPF FULL 12dB 0dB 2CH 4CH 6dB 12dB 0dB 6dB HPF LPF FULL
VEHICLE BATTERY
REM
IN
RL–
INPUT POWER
PROTECT
RL+
INPUT
FL–
INPUT
FL+
INPUT
FR–
INPUT
FR+
INPUT
RR–
INPUT
RR+
INPUT
R–
R+ FL–
FL+ FR–
LOW LEVEL INPUT OUTPUT REM
FRONT REAR
HIGH LEVEL
INPUT
SPEAKER
OUTPUT
LIMITED
POWER INPUT
FULL POWER INPUT
FR+
RL–
RL+
GND
+12V
GND
+12V
RR–
RR+ RL–
RL+
FR–
FR+ FL–
FL+
RR–
RR+ L–
L+
REM
OUT
HPF LPF FULL 12dB 0dB 2CH 4CH 6dB 12dB 0dB 6dB HPF LPF FULL
4 5 6 2
min. 30 A
1
3
< 30 cm >
REM IN/OUT
Connect a turn-on signal or the turn-on remote signal of your head unit (REM) with the REM IN/OUT
terminal of the amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
2
). Hereby
the amplifier turns on or off with your head unit.
If you use the AUTO TURN-ON function (refer to page 22, section 17), the REM IN/OUT terminal
does not need to be connected. However, the REM IN/OUT terminal can then connected to the REM
terminal of another amplifier to provide a control signal to it (REM OUT function).
1