HID Omni-ID Custom ZT410, User Manual

Page: 6 / 8

This chapter provides specific details and guidelines associated with
encoding Omni- ID labels.
1. Setup Printer settings, using main control panel.
2. Optimize RFID encoding settings for Omni- ID labels.
Printer­Settings
6
omni-id.com
Custon ZT410 Guide
Darkness : Darkness should be adjusted to achieve optimal print
quality based on ribbon used.
Print speed : The slowest print speed that is available should
be used to print Compound labels. This is typically 2 inches per
second.
Media Type : Gap / Notch
Print Method : Thermal Transfer
Print Mode : Tear off
Tear off : 0mm
Printer Setup Menu
Run media / ribbon calibration when changing media, follow on
screen instructions. This can be found under tools menu.
Once media calibration is complete, test by pressing feed a
number of times, each time the button is pressed a single label
should be feed out of the printer. If multiple labels are feed
through the printer, repeat the calibration process.
Media/Ribbon­must­be­calibrated­for­each­Media­type­correctly­
Run RFID calibration, found within RFID menu for printer to detect
optimal RF power settings, antenna selection & encoding position.
RFID­settings­must­be­calibrated­each­time­label­type­is­changed