8
4) HDD internal connection
Notice:
-The 4 CH DVR provides 2 removable rack hard drives.
-Hard Disk Master and Slave jumper pin must right, otherwise it makes DVR work fault.
5) Power Connection
Connect the power to the POWER
CONNECTION on the Rear Panel of the
system, and turn on the switch.
6) Turn on the POWER.
Make sure the adaptor is 12V/5A.
7) Detail setup in SYSTEM SETUP
For detail setup, refer to the instruction of SYSTEM SETUP.
1.
Make sure the HDD is MASTER.
2. Make sure the cable connector is
correct.
3.
MASTER set up, please check the
HDD panel.
1.
Make sure the HDD is MASTER and
SLAVE.
2. Make sure the cable connector is
correct.
3. MASTER and SLAVE set up, please
check the HDD panel.
HDD
MASTER
MAIN BOARD
I/O BOARD
Set the drive jumpers as specified by hard disk drive manufacturer.
1
2
3
1
3
2
tie
HDD1
HDD2
MASTER
SLAVE
MAIN BOARD
I/O BOARD
Set the drive jumpers as specified by hard disk drive manufacturer.
2
1
3
1
How to connect single HDD
2
How to connect 2 HDD
