HHP IMAGETEAM 5600, User Manual

Page: 40 / 144

3 - 4
When in serial mode, the scanner scans until a bar code has been read or until
the deactivate command is sent. In serial mode, the scanner can also be set to
turn itself off after a specified time has elapsed (see
Serial Trigger Time Out ,
which follows).
Serial Trigger Time Out
Use this selection to set a time out (in milliseconds) of the scanner’s trigger when
using serial commands to trigger the scanner. Once the scanner has timed out,
you can activate the scanner either by pressing the trigger or using a serial
trigger command. After scanning the
Serial Trigger Time Out bar code, set the
time out duration (from 0-300,000 milliseconds) by scanning digits from the
inside back cover, then scanning
Save . Default = 0 (infinite, or no time out).
Manual Trigger, Low Power
The scanner powers down until the trigger is pulled. When the trigger is pulled,
the scanner powers up and operates until there is no triggering for the time set
with the
Low Power Time Out bar code below. There is a delay of up to one
second in operation when the scanner is first triggered, but there is no delay
when operating in low power timeout mode.
Note: Manual Trigger, Low Power cannot be used with keyboard wedge
applications.
Low Power Time Out Timer
Scan the Low Power Time Out bar code to change the time out duration (in
seconds). Then scan the time out duration (from 0-300 seconds) from the inside
back cover, and
Save . Default = 120 seconds.
If there are no trigger pulls during the “low power time out timer” interval, the
scanner goes in low power mode. Whenever the trigger is enabled, the “low
power time out timer” is reset.
* Manual/Serial Trigger
Serial Trigger Time Out
Manual Trigger, Low Power
Low Power Time Out