HF-LPC3X0 Series Wi-Fi&BLE User Manual
Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com)
- 45 -
AT+E=<status><CR>
+ok<CR><LF><CR><LF>
◼
Parameters:
◆
status: Echo status
on: Open echo
off: Close echo
When HF-LPC300 module firstly switch from transparent transmission to configuration mode, show
back status is open, input “AT+E” to close show back function, input“AT+E” again to open show back
function, use AT+E=on/off command to save the echo status..
4.2.2.2.
AT+CMDPW
◼
Function: Set/Query AT command prefix character for sending AT command in
throughput mode. Setting is valid after reset;
◼
Format:
◆
Query Operation
AT+CMDPW<CR>
+ok=<data><CR><LF><CR><LF>
◆
Set Operation
AT+CMDPW=<data><CR>
+ok<CR><LF><CR><LF>
◼
Parameters:
◆
mode: Default is blank for disable t
是
his function. The maximum is 20 chacter
length, once has been set, the AT command in transparent transmission mode
function is enabled (AT+H and AT+WSCAN are not supported). Do restore to
factory operation to disable and clear the setting
When set this value to
“HF”, then can get response of “+ok=STA”(Hex: 2B 6F 6B 3D 53 54 41) for
send “HFAT+WMODE\r”(Hex: 48 46 41 54 2B 57 4D 4F 44 45 0D, AT command should end with 0D
or 0A).
4.2.2.3.
AT+WMODE
◼
Function: Set/Query Wi-Fi work mode. Setting is valid after reset;
◼
Format:
◆
Query Operation
AT+WMODE<CR>
+ok=<mode><CR><LF><CR><LF>
◆
Set Operation
AT+WMODE=<mode><CR>
+ok<CR><LF><CR><LF>
◼
Parameters:
◆
mode:Wi-Fi work mode
AP
STA
APSTA
