Trimilin models with folding feet
For a „plus“ model with folding feet
(fig. 4)
, simply slide the legs
onto the sockets. Do not use force. The spring inside the folding leg
does the work and actively pulls the leg up towards the frame. If it
gets stuck and is not easy to move, don’t push it. The reason for the
foot to get stuck is that the grey rod inside the leg has been slightly
bent to the left or right possibly during transport or unpacking.
For handling grasp the foot at the bottom of the leg and pull it
off the socket until you see the grey bar. With slight pressure to
the right or left you can now push gently against the rod until it is
completely straight again. The leg should now slide up the socket
effortlessly.
Trimilin models with screw-on legs
The Trimilin comes to you fully assembled. You only need to screw
on the legs. The screw threads on the frame are protected by black
caps so they don’t get damaged during transport. Remove them
and screw on the legs. Please check them regularly to make sure
they are still tightened securely.
Trimilin models with spring
The springs of the Trimilin are hooked on metal cleats which are
welded to the inside of the frame. Check for the correct position
as per
figs. 1 and 2
. If through transport or another impact a spring
was positioned into a corner of a cleat, push it back into the correct
position.
During use, on occasion the friction of the springs on the steel cleats
can cause fine iron filings to fall to the floor. Sensitive floor coverings
should therefore be protected. When a spring breaks stop using the
trampoline and replace the spring first
(fig. 3)
.
Trimilin models with rubber cable
Make sure that the rubber cable has no contact with the socket of
the leg but is placed at least 1 cm away from the leg
(fig. 4)
. The life
span of rubber is limited. Therefore check the condition of the rubber
cables frequently. Thinning parts in the cable indicate a possible
damage of the rubber threads inside the cable. Likewise, if the plastic
sheathing of the cable is damaged the cable should be replaced.
Check that the springs are correctly hooked
in the bends of the metal cleats.
Springs moving into corners should be
pushed back so they do not cause noise
and damage.
2.
1.
Replace spring:
Hook the new spring
into the frame cleat first. Then use a slo-
tted screwdriver to lever the other end of
the spring into the mat cleat.
3.
4.
Make sure the rubber band is placed at a
distance of at least 1 cm from the leg stud.
For space-saving storage, place the
Trimilin vertically, for example against
a wall. But not half inclined, so there is
no weight on the legs.
Trimilin-sport:
Check the protective
eyelets in the frame regularly! If there is a
pronounced notch you can lift the eyelet
and turn it around.
First lift it with a screwdriver. Then turn it
180 degrees around and push it back into
the frame.
AchTUNG! Randbezug anhe
-
ben und regelmässig Feder
n,
Gummikabel und Ösen afu
Regularly lift the frame cover to
check cable, springs or eyelets for
damage and r
eplace defective parts.