16
EN
3. Safety instructions
Target Group:
The manual is intended for users who set up and operate the machine.
Copyright:
The duplication of the manual in whole or in part is only permitted with written permission from
HEYLO GmbH.
Reservation:
HEYLO GmbH reserves the right to make changes and improvements to the product and manual
at any time without prior notice.
Disposal:
The device has been designed for many years of operation. If it is to be disposed of, this must be done in
an environmentally friendly manner in accordance with the relevant legal regulations
Keep away from children
: Do not let children play with or in the vicinity of the unit.
Electrical connection:
The AC25 air conditioner is only designed for operation with 230V/50 Hz. The connection
must be fused with 16A.
Use shockproof plugs and shockproof sockets only! The sockets must be earthed or protected by residual
current circuit-breakers with at least 30 mA.
Protect the power cable from damage
: Never use the device with a damaged power cable. If the power cable is
damaged, replace it with a cable of the same type and dimension.
Extension cables
: Only use approved extension cables!
Handle with care
: Do not drop or throw the unit, as this may damage components or wiring.
Keep dry
: The appliance must not be operated in puddles or standing water. Do not store or operate it outdoors.
If the electrical wiring or parts of the unit get wet, the unit must be thoroughly dried before re-using.
Keep air openings free
: Do not cover or block the air inlets and outlets.
Environment:
Use only in dry,
non
-hazardous areas. Suitable for indoor use only. The room temperature must not
exceed 35°C.
Work on a solid surface
: Always place the device on a solid and plane surface.
Do not tilt during operation.
The air conditioner may only be stored and transported upright.
Failure to do so may cause irreparable
damage
to the compressor. If the unit should nevertheless be transported in a horizontal position, we recommend
a waiting period of 24 hours before putting into service.
Never pull the power plug before the unit has been switched off at the ON/OFF switch.
