HEXFLY PRO-X4, Manual

Page: 13 / 24

10
WWW.HEXFLY.COM
The next screen will ask to confirm the settings after the charger examines the
battery, giving a cell count The "R:" value shows the number of cells detected
by the charger. The "S:" value shows the number of cells you selected in the
previous menu screen. If the "R:" value does not match the "S:" value, the
charger is seeing a different cell count than you have selected. If this
happens, press the Batt Type/Stop button to check the number of cells you
have selected. If this is correct compared to the battery, you may have a
problem with your battery. If the values are the same, it is safe to charge at
this point. Press and hold START/ENTER to start the charge sequence.
Like a standard charge sequence, the value in the lower left hand corner of the screen shows the selected
charge current and the value in the lower right hand corner of the screen shows the selected voltage of the
pack that will be charged. To change these values, press the START/ENTER key to cycle through the
adjustable settings. Use the increase/decrease buttons to change the values
and use the START/ENTER button to confirm the values. When the values
have been set correctly and you are ready to BALANCE charge, press and
hold the START/ENTER button for 3 seconds to begin the process.