16
Using Bluetooth® mode
After downloading and installing your application, you
can start it. For your information, the 2019 logo is:
Then you should:
1.
Connect your phone to the robot (connected
to the electronic box itself plugged to the
mains) nearby by pressing “DISCONNECTED! "
2.
Select the device corresponding to yours.
3.
You can now use your device in Bluetooth
radio control mode with the same
functionality as the radio control
Operation of the interface:
It is identical to that of the radio control
(see previous
page).
D.
Output from the water
After its automatic operation cycle the robot stops itself.
To remove it from the water, perform the following
procedure:
1.
Bring the robot back to you in the shallowest
part of the pool and mount it on the wall in front
of you in manual mode (using the remote
control or the Bluetooth application).
2.
To get it out of the pool, pull it
by the handle
and no longer by the cable and let the water
drain.
3.
Unplug the control box from the mains.
4.
To better maintain your filtration, we
recommend that you immediately remove the
filter holder and filter bag. Wash them with fresh
water and rinse your SPOT PRO 100.
5.
Roll up the cable. If a twist occurs on the cable,
remove it (as you would with an extension cord). Please remove any twists from the
cable (and do not just distribute the twists along the length of the cable).
6.
Finally, store the robot.
