2.
Do one of the following:
• Lock the internal locker.
• Leave the internal locker in unlock position if you want to access the front panel any time without
removing the access panel.
4.
Do one of the following:
• Server in rack mode:
Install the server into the rack
on page 39.
• Server in tower mode: Return the server to an upright position.
5.
Connect all peripheral cables to the server.
6.
Connect each power cord to the server.
7.
Connect each power cord to the power source.
on page 42.
Install the server into the rack
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
Grasp the tray notch and extend the server tray out of the rack.
Removal and replacement procedures
39
