Hewlett Packard Enterprise FlexFabric 5940 Series, Configuration Manual

Page: 34 / 123

28
Figure 5 Network diagram
Configuration procedure
# Assign port priority to Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2. Make sure the
priority of Ten-GigabitEthernet 1/0/1 is higher than that of Ten-GigabitEthernet 1/0/2.
<DeviceC> system-view
[DeviceC] interface ten-gigabitethernet 1/0/1
[DeviceC-Ten-GigabitEthernet1/0/1] qos priority 3
[DeviceC-Ten-GigabitEthernet1/0/1] quit
[DeviceC] interface ten-gigabitethernet 1/0/2
[DeviceC-Ten-GigabitEthernet1/0/2] qos priority 1
[DeviceC-Ten-GigabitEthernet1/0/2] quit
Priority mapping table and priority marking configuration
example
Network requirements
As shown in Figure 6 :
•
The Marketing department connects to Ten-GigabitEthernet 1/0/1 of the device, which sets the
802.1p priority of traffic from the Marketing department to 3.
•
The R&D department connects to Ten-GigabitEthernet 1/0/2 of the device, which sets the
802.1p priority of traffic from the R&D department to 4.
•
The Management department connects to Ten-GigabitEthernet 1/0/3 of the device, which sets
the 802.1p priority of traffic from the Management department to 5.
Configure port priority, 802.1p-to-local mapping table, and priority marking to implement the plan as
described in
Table 2 .
Table 2 Configuration plan
Traffic
destination
Traffic priority order
Queuing plan
Traffic source
Output
queue Queue
priority
Public servers
R&D department >
Management
department > Marketing
department
R&D department 6 High
Management
department
4 Medium
Marketing department 2 Low