Hewlett Packard Enterprise FlexFabric 5940 Series, Configuration Manual

Page: 44 / 123

38
Step Command Remarks
3.
Configure GTS for a
queue.
qos gts queue queue-id cir
committed-information-rate
[
cbs
committed-burst-size
]
By default, GTS is not configured
on an interface.
Configuring the rate limit for an interface
The rate limit for an interface specifies the maximum rate of incoming or outgoing packets on the
interface.
To configure the rate limit for an interface:
Step Command Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure the rate limit
for the interface.
qos lr
{
inbound
|
outbound
}
cir
committed-information-rate
[
cbs
committed-burst-size
]
By default, no rate limit is
configured on an interface.
Displaying and maintaining traffic policing, GTS,
and rate limit
Execute
display
commands in any view.
Task Command
Display QoS and ACL resource usage.
display qos-acl resource
[
slot slot-number
]
Display traffic behavior configuration.
display traffic behavior user-defined
[
behavior-name
]
[
slot slot-number
]
Display GTS configuration and statistics for
interfaces.
display qos gts interface
[
interface-type interface-number
]
Display rate limit configuration and statistics
for interfaces.
display qos lr interface
[
interface-type interface-number
]
Traffic policing, GTS, and rate limit configuration
example
Network requirements
As shown in Figure 11 :
•
The server, Host A, and Host B can access the Internet through Device A and Device B.
•
The server, Host A, and Ten-GigabitEthernet 1/0/1 of Device A are in the same network
segment.
•
Host B and Ten-GigabitEthernet 1/0/2 of Device A are in the same network segment.