- 1 -
Industrial Sole Cleaning Devices
Solamat 400
/ Art.-No. 065-4000 (dry)
Solamat 450
/ Art.-No. 065-4500 (dry with suction)
Solamat 500
/ Art.-No. 065-5000 (wet)
Operating instructions
State: 2008/11
Power supply:
All machines will be delivered „ready for use“ with a standardized power connector. Please make sure
that the power specification on the rating plate is consistent with your actual power supply (110 volt
or 230 volt).
Installation and putting into operation:
The location needs to be roofed over and frost-proof in order to protect the machine and its electricity.
For a secure stand the ground should be plane; rubber stripes may be used for levelling.
After removal of packaging and protection provide for the aforementioned placement as well as power
supply and the
Solamat
cleaning device will be ready for use.
Solamat 450
should be connected to the industrial vacuum cleaner which is available optionally. To
do so, attach suction hose to the Solamat 450 and cleaner and put he power cord of the Solamat 450 in
the power supply of the industrial vacuum cleaner. The cleaner itself will have to be connected to the
mains and provides power to the Solamat 450 automatically.
For
Solamat 500
please screw the drip-off grate to the main cleaning device and attach an ½“ water
supply to the adapter (1 in picture 1) which leads to the magnetic valve.
Picture 1
A pressure of 3 to 5 bar can be applied to the water supply. The freshwater discharge can be regulated
by means of the dial on the magnetic valve (2 in picture 1).
Furthermore, a cleaning medium can be fed additionally with the 6 mm Ø hose (1 in picture 2 – 2
feeds the cleaning medium to the brushes inside the machine). The throughput of this additional
cleaning medium can be adjusted as well.