45 / 88
en
Rev. 03 / 02.2021
AB3200
Software description
STO 1
PROG
T/°C
RCF
RPM
t/min
STO 5
PROG
T/°C
RCF
RPM
t/min
Program store..
PROG
T/°C
RCF
RPM
t/min
5 20 9/;\9 1500 2:00
PROG
T/°C
RCF
RPM
t/min
N > ROTOR MAX in Prog 5
PROG
T/°C
RCF
RPM
t/min
Runtime 00:00 in Prog 5
PROG
T/°C
RCF
RPM
t/min
Empty Program 5
PROG
T/°C
RCF
RPM
t/min
Ramp Unit Time in Prog 5
PROG
T/°C
RCF
RPM
t/min
1 20 9/;\9 1500 2:00
PROG
T/°C
RCF
RPM
t/min
RCL A
PROG
T/°C
RCF
RPM
t/min
RCL D
PROG
T/°C
RCF
RPM
t/min
Multi program recall..
PROG
T/°C
RCF
RPM
t/min
D 19 9/;\9 > 63< 2:00
PROG
T/°C
RCF
RPM
t/min
1.
Press the
[PROG] key until STO 1 is displayed.
2.
Use the
[adjusting knob] to set the desired program location.
If a ‘+’ is displayed after the program location, the
data is write-protected.
In this case, the write protection has be removed first
before saving is possible
3.
Press the
[START] key.
4.
You can now run the saved program with the lid closed with the
[START] key.
7.1.3
Calling up/loading a program link (RCL A-Z)
If ‘N >ROTOR MAX in Prog’, ‘Runtime 00:00 in Prog’,
‘Empty Program’ or ‘Ramp Unit Time in Prog’ is displayed
for program links, a centrifugation run cannot be
Chapter 9 ‘Troubleshooting’ on page 72.
"Program linkage" can be used to link several centrifuge
operations together.
A program link is only possible if this is activated (parameter
‘Multi programs = on’
Chapter 7.3.5.8 ‘Multi programs’
To call up (load) a program link, proceed as follows:
1.
Press the
[PROG] key until ‘RCL A’ is displayed.
2.
Use the
[adjusting knob] to set the desired program location.
3.
Press the
[START] key.
4.
You can now run the loaded program link with the lid closed with the
[START] key.
