www.hetronic.com
S
TARTING
Y
OUR
T
RANSMITTER
1. Confirm that all equipment manufacturer safety
measures have been followed.
2. Turn ON the receiver.
3. Insert batteries into the battery compartment.
4. Press, release
START
to turn ON, then press
START
again after green LED starts blinking.
The following results appear quickly:
5. Test all machine functions in a safe place to
ensure that the machine responds as expected.
WARNING: To avoid accidental start-up,
always press the STOP pushbutton (Memory
Key) when not in use.
Result
Meaning
Diagnostic LEDs turn ON.
Checking for
Memory Key.
Diagnostic LEDs turn OFF.
Memory Key
check is complete.
Green LED starts blinking.
Transmitter data is
being transmitted.
!
Front
Back
Battery
Memory Key
Battery
Compartment
Diagnostic
LED
Toggle Switch
R
EAD
T
HIS
F
IRST
B
EFORE
O
PERATION
Check the condition of your transmitter once a day,
before the start of an operation and at all shift
changes:
• Visually check the transmitter for any physical
wear or damage.
• Confirm that you can read and understand all of
the safety labels.
H
OLDING
Y
OUR
T
RANSMITTER
Hold the transmitter upright with the front facing you.
Confirm that you are able to easily read and
understand all operation text and symbols.
DANGER: Do not operate this transmitter
unless you have been trained in the safe and
proper operation of the radio control system
and the machinery it is to control.
Be alert to unsafe conditions and be aware
that radio remote control commands can take
place around obstacles and out of your direct
sight.
ALWAYS confirm that the machine and
remote control STOP functions work properly
BEFORE beginning any machine operation.
Turn OFF the transmitter when not in use.
Remove the Memory Key when the unit is
placed any distance away from you.
WARNING: Test the STOP function. NEVER
operate the machine if the STOP function
does not work properly.
WARNING: Never operate a transmitter with
worn or damaged parts.
WARNING: Holding the transmitter
improperly while operating your machine
could result in unexpected machine response
!
!
!
!
S
TOPPING
Y
OUR
T
RANSMITTER
Press
STOP
.
The transmitter sends the STOP telegram to the
receiver for 2 seconds minimum.
Upon receiving the STOP telegram, the receiver
goes into Safe Mode and turns OFF all of the
receiver outputs.
The transmitter shuts off in about 2 seconds.
U
NDERSTANDING
S
TATUS
L
IGHTS
A diagnostic LED Status Light on the face of the
unit provides continuous operating status
information.
See Status Lights descriptions below:
• Green (Flashing) - Transmitting Telegram
• Red (Flashing) - Transmitting STOP Telegram
• Red (Steady) - Low Battery
• Red (slow pulsing) - Invalid Memory Key
DANGER:If your machine does not
operate as expected. Shut down the
system immediately and contact your
supervisor for next steps.
WARNING: Improper operation,
maintenance or adjustment may cause
serious injury or damage to equipment and
may void the warranty.
!
!
