HETEC V - IP, Quick Installation Manual

Page: 4 / 7

The Quick Start Guide
Initial Network Configuration
Initially, the V-IP network interface is configured with the parameters shown in Table
1-1 .
Table 1-1. Initial Network Configuration
Parameter Value
IP auto configuration DHCP
IP address -
Netmask 255.255.255.0
Gateway none
IP access control none
Warning
If the DHCP connection fails on boot up, V-IP will not have an
IP address.
If this initial configuration does not meet your local requirements, adjust the values
to your needs. You may either configure the V-IP via serial interface, or use the setup
tool that can be found on the CD ROM delivered with this package.
V-IP Setup Tool
Main Window
Figure 1-3. V-IP setup tool
Connect the V-IP to your computer either via local network or via USB. Start the setup
tool from the CD ROM on the computer where the V-IP is installed. Depending on
the connection (USB or network), the device detection is different. A window opens
as seen in Figure 1-3 .
3