4. Remove the hood from its packaging and place the back of the hood on the floor or countertop
in front of the wall where it will hang. Save the trim kit and hardware for step 10.
5. Remove the shield(s) and blower housing(s) as follows:
a) Remove the shipping tape that is securing the blower shield(s) inside the hood.
b) Remove the shield(s) by lightly pulling it toward the front of the hood.
c) Gently close the back draft damper(s) from the top side of the hood.
d) To remove the blower housing(s), unsnap the suitcase latches (one on each side of the
housing).
e) Support the
housing and pull it straight away from the blower housing, then tip it back
toward you to clear the blower wheel(s), and then lower it from the hood.
Make sure power is off at the supply panel / breaker during service or installation.
6. One blower motor must be removed from each blower assembly to access the connection
box(es). The blower assembly will have a decal identifying the location of the connection
box(es). It is not necessary to remove the blower wheel from the motor.
a) Remove the three screws retaining the blower motor.
b) Pull the motor out far enough so you can reach its electrical connector.
c) Unplug the connector, set the blower motor and screws aside.
7. WIRING PREPARATION: Install an appropriate 1/2” UL listed electrical wire clamp through
each motor box electrical opening on top of the hood. Install electrical wiring from the service
panel to the hood location for each motor box. Consult the connection diagrams (on previous
page) for further details on electrical placement.
See “MODEL NUMBERS” on page 4 for power requirements.
8. This step will require the fasteners and hardware in the trim kit.
a) The liner must be lifted into place while guiding the wires into place and aligning the
duct(s) with the exhaust collar(s) or transition.
b) The liner should be flush with the enclosure or slightly above.
9. Install a wood screw with countersunk washer and flat washer into each mounting hole along
the bottom edge of the liner.
10. Trim Installation:
a) Install the trim piece for the back side of the
liner by hooking one side under the bottom
edges of the back countersunk washers.
b) Snap the trim piece over the top of the
countersunk washers by applying pressure
upward and toward the liner wall.
c) Repeat this process for the front trim piece.
d) After the back and front trim pieces are
installed, use the same process for the side
trim pieces.
Liner Trim Kit
Flat nylon washer
Countersunk
nylon washer
Wood screw
Trim piece
INSTALLATION
(CONT.)
©2018 Hestan Commercial Corporation
13
EN