IMPORTANT NOTES TO THE CONSUMER
Keep this manual with your Use and Care Manual for future reference.
• As when using any microwave oven generating heat, there are certain safety precautions you
should follow. These are listed in the Use and Care Manual. Read all and follow carefully.
• Be sure your Drawer Microwave is installed and grounded properly, in accordance with local
codes by a qualified installer or service technician.
IMPORTANT SAFETY INSTRUCTIONS
If the information in this manual is not followed exactly, a fire or electrical shock
may result that could cause property damage, personal injury or death.
To reduce the risk of tipping, the Drawer Microwave must be secured by a properly
installed Anti-Tip block.
Do not install drawer in any combustible cabinetry unless it meets the stated
clearances and dimensions on the following pages. See Figure 1, 2 and 3.
• Make sure the wall coverings and the cabinets around the Drawer Microwave can withstand the
heat generated by the appliance.
Never leave children alone or unattended in the area where a Drawer Microwave is
in use. Never leave the drawer open when the microwave is unattended.
Stepping, leaning or sitting on the drawer may result in serious injuries and can also
cause damage to the Drawer Microwave.
• Do not use the Drawer Microwave as a storage space. This creates a potentially hazardous
situation.
• Check that the time of day is in the display. If not, touch
Stop/Clear
to prevent unintended use.
CLEARANCES AND DIMENSIONS
ABOUT DIMENSIONS
• Figure 1 shows dimensions of the unit. Figures 2 - 3 provide minimum clearance for standard
(non-flush) installation. Figures 4 - 9 show clearances and additional information for flush
installation. Suggested electrical outlet location is shown in figures 2 - 6.
1
• Contact surface must be solid and level. Pay special attention to the floor on which the Drawer
Microwave will sit. The floor of the opening should be constructed of plywood strong enough
to support the weight of the unit–about 100 pounds [45 kg].
• Check location where the Drawer Microwave will be installed for proper electrical supply.
• Your Drawer Microwave can be installed into a cabinet by itself or below any electric or gas wall
oven. Be sure that the clearance of the floor between the wall oven and the Drawer Microwave
is a minimum of 2 inches [5.1 cm].
• Always check electrical codes for requirements.
The Drawer Microwave must be placed close enough to the electrical outlet so that
the cord is not under tension.
See Figures 1 - 6 for required clearances and dimensions when planning the drawer’s location.
1
An electrical outlet in an adjacent cabinet can be used, as long as the provided electrical cord
can reach without pulling tight. Power cord access hole in cabinet should be a minimum 1 1/2" [3.8
cm] diameter hole and deburred of all sharp edges.
©2019 Hestan Commercial Corporation
3
EN
