TROUBLESHOOTING
(CONT.)
CODE
FAULT
DESCRIPTION
E6
Delicate Daily Wash Super/
Sanitize
Crystal
Soak
Water pump-out malfunction
The appliance does not pump out the water or does so
incorrectly. Make sure the drain hose is not kinked or
crushed and that the siphon and filters are not clogged.
If the problem persists, contact Technical Service.
E7
Delicate Daily Wash Super/
Sanitize
Crystal
Soak
Turbine flow-regulator malfunction
The appliance is unable to precisely measure the
quantity of incoming water. Interrupt the current cycle
and turn off the dishwasher. Turn it back on again,
program a new cycle and press start. If the problem
persists, contact Technical Service.
E8
Delicate Daily Wash Super/
Sanitize
Crystal
Soak
Alternate washing system malfunction
Interrupt the current cycle and turn off the dishwasher.
Turn it back on again, program a new cycle and press
start. If the problem persists, contact Technical Service.
E9
Delicate Daily Wash Super/
Sanitize
Crystal
Soak
Water intake system malfunction
Contact Technical Service.
E11
Delicate Daily Wash Super/
Sanitize
Crystal
Soak
Wash motor pump malfunction
Contact Technical Service.
If an alarm situation occurs, the dishwasher interrupts the current program and signals the
problem.
• Alarms E1, E2, E3, E4, E8 and E9 immediately terminate the current cycle. Alarms E5 and E6
interrupt the current cycle and, after the problem has been eliminated, resume the cycle.
• Alarm E7 is displayed at the end of the cycle, which however, is completed given that it does
not jeopardize the operation of the dishwasher.
• For alarms E9, E11, contact customer service.
TO CLEAR AN ALARM:
1. Open or close the door or switch off and back on again.
2. If the error clears, the dishwasher can then be programmed again.
If the problem persists, contact an authorized technical servicer.
Light off
Light on
Light flashing
©2019 Hestan Commercial Corporation
33
EN
