HE 5750 Operating Instructions
#371627 | Version 1.1
29
7.10 System start
For a successful system start, the following conditions must be fulfilled:
wiring all components according to wiring diagrams
power supply of all components switched on
system parameters completely entered
compressed air for valves available
There are three different start options:
1. local control at Master control cabinet
2. start with SmartTool
3. start from process control
The active cleaning process is indicated on the display of the controller and by indicator lights
at the control cabinet. A start with the controller is not possible.
Once the controller is switched on, it starts monitoring
the CAN network,
the conformity of parameter set and system
the check of necessary values (pressures etc.)
Alarm messages (alarm triangle in system status screen) can be accessed by pressing the F6
key. Chapter
messages gives information about troubleshooting.
Info screen
F2 disconnects the
start-up routine for 1
minute. F1 continues the
start-up process.
CAN open management
1. Waiting for Slave
messages
2. Preparation
3. Sending parameters
4. Check
Actual system status
-Cleaning status
-Actual chamber / valve
- Delta-p symbol
- Delta-p measuring value
- System pressure
Power on
Info screen
CAN management
Actual system status
End of start-up
routine
