HESA KUNTC15IR, User Manual, Page: 34 / 40

34/40
When motion/alarm is triggered, there are 3 different types of
record mode.
1. AVI File (With Record File Setting )
2. Multi-JPEG (With Record File Setting), only with JPEG
compression format.
3. Single JPEG (Single File with Interval Setting)
c. Record Time Setting Pre Alarm and Post Alarm setups for video
start and end time when motion detected, I/O, or other devices got
triggered.
Note: Pre/Post Alarm record time is base on record time setting and IP Cam
built-in Ram memory. Limited by IP Cam built-in Ram Memory, When information
is too much or video quality set too high, it will cause recording frame drop or
decrease on post alarm recording time.
d. Network Dis-connected
When the network is down, it will save the video to local SD card.
This function is only enabled in wire connection.
e. Network IP check
For the use of recording software, IP CAMERA supports the
detection of network connection. Whenever the connection is down,
it records the video to SD card. To use this function, key in the IP
address of the PC which is installed in the recording software, and
enable the function of “Save to SD card”, then click “Apply”.
The interval of two video files on SD card is fixed with 30 seconds.
ii I/O Setting
IP Camera supports 1 input/ 1 output. When input is triggered, it can
send the video to some specific mail addresses, transmit the video to
remote ftp server, trigger the relay, and save video to local SD card.
iii Mail & FTP
To send out the video via mail of ftp, please set up the configuration first.