CAUTION:
•
Ensure mains power is OFF before commencing an installation involving fixed wiring.
•
Any fixed wiring outside the heater coming into contact or close proximity to the heater must be protected
by sleeving with a temperature rating of at least 90°c.
•
All cabling behind the appliance must take the shortest route to the edge of the heater.
•
Ensure that the power cable is not coiled. Shorten the power cable if possible and do not place excess cable
on the rear of the heater.
•
Electrical connections must not be made behind the heater regardless of wall or ceiling-mounting position.
•
The heater is not to be located immediately below a socket outlet in either wall or ceiling-mounted
positions.
•
DO NOT
drill through the heater as this will cause irreparable damage and is also dangerous.
•
DO NOT
connect a heater that is damaged in any manner to the power network.
When ceiling mounting use the narrower slide-in channel in the brackets supplied.
When wall or ceiling mounting ensure that the adjustable spacing feet in the corners are screwed out until a
slight pressure is established between the panel and the mounting surface.
For mounting the Herschel panel use the supplied mounting hardware only and install in accordance with the
installation guide. Herschel Infrared Ltd cannot accept responsibility for damage, loss or injury caused by, or
resulting from incorrectly installed heaters. Herschel Infrared Ltd will not assume liability for consequential
loss however caused.
MAINTENANCE AND REPAIR:
The Herschel panel must be installed, uninstalled, cleaned or transported only when cold.
CLEANING:
Before attempting to clean the panel, unplug the heater, isolate the unit from the electrical supply and allow it
to completely cool down.
DO NOT
immerse the Herschel panel heater in water or splash water onto it.
Clean the heater with a damp cloth . For glass models glass cleaner can be used. Never use a wet cloth. When
clean, dry the surfaces with a dry cloth.
DO NOT
apply abrasive materials, solvents or solvent wipes to the surface as this can cause irreparable damage.
Wait until the unit is completely dry before use.
REPAIR:
DO NOT
attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your
warranty.
Repairs must only be carried out by an authorised Herschel service partner.
DISPOSAL:
The heater is an electrical product and at the end of its working life it should be disposed of in accordance with
local regulations.
OPERATION:
If operated as a fixed space heater, Herschel Inspire
must
be controlled by a Herschel iQ thermostat. European
regulations from January 2018 require all fixed electric space heaters to use a controller incorporating a
minimum of a 7 day programme and temperature control plus at least one of the following:
•
Window open detection (available on all iQ controls)
•
Remote controller or remote application (optional with purchase of iQ Hub)
