ENGLISH
INITIAL USE:
The power switch on the side of the COLORADO has 3 positions:
•
Position O (Off)
•
Position I (Remote bypass)
•
Position II (Remote control).
CAUTION:
The power switch may become unintentionally switched to position I (Remote Bypass) during unpacking and
installation. To avoid any possibility of burns, ensure the power switch is in the OFF position (marked
O
on
the switch) before switching on mains power.
Position I. To bypass the remote control, turn the switch on the heater to position I. When the switch is in
this position the heater will turn on or off depending on whether it has power to it. The remote control unit
will not control the heater when the switch is in position I. Use this where you wish to hard wire the heater
to a switching device such as a push button timer or thermostat.
Position II. To use the heater with the remote control, ensure the switch of the heater is switched to
position II.
Insert 2 x AAA Alkaline batteries into the remote control.
The remote control operates the heater remotely on or off with adjustable heat level and timer described
below. All Herschel remote controls have the same frequency, so it is possible to control several heaters
with just one remote.
There may be odour or vapour from the heater on initial use or if it has not been used for an extended
period. This is normal.
OPERATION BY REMOTE CONTROLLER:
All Herschel remote controls have the same frequency, so it is possible to control several heaters with just
one remote.
Remote Control Function
Button Function (Heater On)
Function (Heater Off)
LED Display on
Heater
1
Turns heater on or off
2
Increase Heat Level or
Timer hours
Turns heater on to
Level 1 (minimum)
L1
3
Decrease Heat Level or
Timer Hours
Turns heater on to
Level 4 (Maximum)
L4
4
Enable Timer
adjustment
00 - 24
5
Enable Heat Level
adjustment
L [n]
