USER MANUAL
H-BLACK MR8 EBIKE
Made in Finland
EN
Herrmans Oy Ab
PB36
68601 Jakobstad, Finnland
+358 20 134 5100
www.herrmans.eu
General:
This product is intended to be used assembled on a bicycle for trekking, commuting, and on-road applications. Product is not intended for off road use.
The light works with 6-12V (DC) current. Operation with a dynamo (AC) is not possible, separate dynamo (AC) version available. Total measured light output of this
product is 180 lumens. Product is in accordance with the German StVZO-, and French TP RBi requirements. The supplied clear front retro reflector meets the Euro-
pean EI A, and the German K regulations. Approval numbers can be found on top part of the front lens, and on front surface of the retro reflector.
Powering the light on and off is handled from the control panel on the bicycle, lamp itself has no on-off -switch.
Assembly:
Fasten the bracket (3) to the front fork of the bicycle. (It is also possible to use just the upper part of the Multi joint bracket to mount the light to 10mm stem plate
interface, if available.) Connect the cables (4) to the electric system according to the drive unit manufacturers specifications. Make sure to connect the cables the
correct way. The minus (-) cable is marked with grey; sometimes the minus is also referred to as “ground”. The plus (+) cable is plain black. For a clean assembly, it
is possible to route the cables smoothly through the front bracket as seen in the first of the two images. The front reflector (7) is attached by simply clicking it in
below the main body of the light.
Notice:
Attach the cables properly to the bicycle to prevent them from getting entangled with moving parts, nor getting pulled too taut once operating the bicycle.
Adjusting:
The light pattern is designed with a distinct cut off line; there is almost no light at all guided above this line. This makes it possible to have broad coverage, and not
to dazzle the oncoming road users at the same time. Keeping this in mind, adjust the light accordingly; make sure not to point the light too high. Road view light pat-
tern can be seen in the second of the two images.
Care and disposal:
The Light is generally designed to be maintenance free in its intended use scenario. The LED will last the lifetime of the lamp.
When cleaning is needed use a damp cloth, and mild general detergent. Do not submerge the light unit, as this is likely to cause damage. Take care not to scratch
the front lens, as this can impair the performance of the light.
Do not dispose the product within household waste. Dispose the product according to WEEE -regulations at a certified collection point.
This product is guaranteed against defects in materials, and craftmanship for a period of two years.
For more information consult your retailer, or contact [email protected].
7. Click-in EIA, K approved front reflector
8. M4 allen key bolt x2 & M4 nut x2
4. Power connectors
5. Front lens
6. Side windows
1. Aluminium top cooling element
2. Non-rotatable back cover
3. Multi joint bracket
2. 180 lm
1. H-Black MR8 ebike
21
21
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
www.herrmans.eu
www.herrmans.eu
www.herrmans.eu
www.herrmans.eu
http://www.nordiclights.com
http://www.nordiclights.com
http://www.nordiclights.com
http://www.nordiclights.com
