Heronation Soomo Rotoblade Grand, Manual

Page: 4 / 14

www.soomotoys.com p. 4 www.soomotoys.com
Plug the charger into the power supply socket, and insert the charger
connector into the charging wire of the Lithium battery. The charging
time is normally 120 minutes or so. You can use it after charging is
completed. Overcharging may lead to fire and explosion.
Attention:
1. Make sure the voltage and connector plug of the adapter match with
the local charging standard.
2. You should not leave when the battery is in the process of charging.
3. The battery will be hot when the helicopter has finished flying, please
wait at least 30 minutes to cool it for protection.
4. Do not throw the battery into the fire to avoid explosion.
Attention:
Please turn the switch to OFF if you are not playing the helicopter for
power conservation.
Helicopter Charging
MAINS ChARGING
220V
AC
frequency pairing
SWASH PLATE ADJUSTMENT
To pair the frequency of this model for the first time:
1. Push the throttle joystick to the lowest position and turn on the power
of the remote controller at the same time. Extend the antenna.
2. Turn on the power on the helicopter.
3. When the light of the receiver changes from flashing quickly to
flashing slowly, the frequency pairing is complete and you can play.
1. Inspection of swash plate adjustment: Turn on the remote
controller, move the throttle joystick and throttle trimmer to the lowest
position, and move the elevator trimmer and aileron trim to the
neutral position. Inspect whether the swash plate is horizontal or not.
2. Adjustment of swash plate: If the swash plate is not horizontal, you
can adjust it with the following steps:
- Elevator and aileron adjustment. Loosen the steering engine bell
crank screws and then reconnect the power of the helicopter.
Adjust the steering engine linkage rod bell tank to a 90° angle after
repositioning the elevator and aileron. Retighten the screws.
- Adjust the length of the steering engine linkage rod to make the
swash plate horizontal.