HermanMiller
Assembly Instructions
2
1BKWR9 rev B
2.2 Peel protective fi lm from Hook Strip.
2.3 Adhere to side panel with a 3mm gap between Vertical Rail and Hook Strip,
Horizontal Spacer and Hook Strip.
2.4 Press Hook Strips fi rmly against side panel along entire length of both
strips. This is critical for good adhesive bond to side panel.
2.5 Install all hook strips for all panels fi rst, moving in a circular movement
around unit. Once all hook strips are installed, begin installing pads. Start
with fi rst set of hook strips that were installed. Move in same direction as the
hook strips were installed.
3.1 Align corner of External Acoustic Pad by mating top edge of Loop Strip on
back of pad with bottom edge of horizontal spacer on side panel. Mate Loop
strip side edge with vertical rail edge.
3.2 Hold pad against rail. Align Hook Strip on pad with Loop Strip on side
panel. Press pad onto side panel.
3.3 Repeat for other side of pad. Note: top edge of pad should be 1/4” above
top edge of side panel.
3.4 Press fi rmly from top to bottom over pad side edges to make sure hook
and loop strips are fully engaged and to provide extra pressure to hook strip
adhesive.
Hook Top Strip
Hook Strip
Rail
Side Panel
Side Panel
Loop Strip
Align
Align
Loop Strip
Hook Strip
Vertical Rail
Top of Pad
Top of Rail
Vertical Rail
Horizontal Spacer
(Solo Space Only)
External Acoustic Pad
Rail Edge
Spacer Bottom Edge
1/4”
3 mm
3 mm
Step 3
Step 4
4.1 If installing multiple External Acoustic Pads, adjust position of pad edges to
achieve even gap from top to bottom between each pad.
Rail
Spacer
Spacer
Spacer
External Acoustic Pad
External Acoustic Pad
External Acoustic Pad
