Step 9
8.1 Locate wall stud behind soffit with stud finder. Secure end of teather to
wall with screw.
8.2 If Stud is not directly in-line to Tether a Toggle may be used.
Screw
Teather
Wall Stud
Step 7
Step 8
9.1 Position Front Panel Support Bracket over screw heads on base panel.
9.2 Push front panel in until all zero side mount screws fully engage into zero
side mounts.
Bumper
Bumper
#10 x 3/4
Pan Head Screw
.25”
Front Panel Support Bracket
Zero Side Mount Screw
Zero Side Mount
Front Panel
Screw Head
Screw Head
Preventing Front
Panel From Sliding Off
7.1 Remove protective backing from bumpers. Place one on outside edge of
end panel at each end. Place one centered on outside edge of base panel.
7.2 Insert 2 #10 x 3/4 pan head screws into base panel.
7.3 Leaving them up .25” from base panel.
Disassembly and Recycling:
Materials Identification and Segregation:
Where possible, plastic components are marked with ASTM recycling
codes. Use these codes to identify material type for recycling. Non marked
components should be treated as mixed plastic. Ferrous metals can be
identified using a small magnet for recycling. Non-ferrous metals should be
separated and recycled separately.
To disassemble product, reverse the above installation steps.
HermanMiller for Healthcare
Assembly Instructions
4
1BKN3K rev B
