3
HermanMiller
Installation Instructions
1BMYW4 rev C
For more information about our products and services please visit us at
hermanmiller.com or call (800) 851 1196.
©2019 Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No.
1BMYW4 – C
Disassembly and Recycling:
Materials Identification and Segregation:
Where possible, plastic components are marked with ASTM recycling
codes. Use these codes to identify material type for recycling. Non
marked components should be treated as mixed plastic. Ferrous metals
can be identified using a small magnet for recycling. Non-ferrous metals
should be separated and recycled separately.
To disassemble product, reverse the above installation steps:
Step 9
Step 8
9.1 The power supply may be suspended from the bottom of the Chase
using the Under-Chase wire manager. The wire manager also helps to
control any extra cord from the T-Light.
8.1 Route the power cable along the bottom side of the Chase (Cable
Management Clip is available to help with this) and plug the barrel
connector into the T-Light Power Supply. Plug the AC Cord from the
Power supply into an outlet.
Step 7
7.1 Thread the power cable through the slots in the bottom of the cord
cover. Place the Cord Cover next to the Support Post and hook the
bottom of the cord cover under the bottom edge of the Chase and then
rotate the cover down to snap the cover into the slots of the Chase.
