Z
4
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
®
Y
,
Z
and Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b6pd2 rev B.
A
1. Place Harness Body into Bracket to one side of Bracket Hooks at left side of
Connector Block.
2. Slide Connector in Receptacle into Power Harness. Press further until
Mounting Lug fully engages into Bracket Hook and Spring Tab seats onto
Harness Body.
3. Route Harness down and through Mid-Run Support or Power Entry Shroud.
If Harness is wired to building then feed harness connector up into Mid- Run
Support or Power Entry Shroud first.
1. Spread open Spring Tabs.
2. Slide Harness Body away from Power Harness until Mounting Lugs clear
Bracket hooks. Harness can now be pulled away from assembly.
Installation:
Removal:
Power Harness
Connector
Block
Receptacle Bracket
Bracket Hook
Spring Tab
Connector
Mid-Run Support
Power Entry Shroud
Mounting Lug
