Connecting the Solvent to the Washer
Placing Equipment in the Gun Washer
1)
Insert the drain pipe and siphon tube into a fresh
To clean guns not mentioned here, use the long or short
5 gallon solvent can and secure the plug in the opening.
stem supports as needed (see pg.11). For questions or
adapter kits contact your paint gun washer distributor.
2)
The can must contain at least 2.5 gallons of solvent to pump
properly. Use a high quality solvent.
Siphon Feed Guns
Place the gun siphon tube on the short stem support.
Preparing the Equipment to be washed
1)
Remove paint cup or paint line and the air line from the
Gravity Feed Guns (HVLP)
paint gun.
Place the long stem support over the short stem
support. Place paint inlet of gun on long stem support.
2)
Drain excess paint from cup and gun.
Place the air cap assembly over the air inlet of the gun to
prevent solvent from entering the passage.
3)
Remove all gauges and regulators from painting equipment.
Pressure Feed Guns
4)
Lock the gun trigger in the open position by placing the
Place long stem support over the short stem support.
trigger lock around the gun handle and trigger (see fig.3).
Place paint inlet of gun on long stem support.
Pots and Cups
CAUTION
Place a pot or a cup on the cup holder.
All pressure gauges must be removed before placing the
equipment in the gun washer to avoid damaging the
gauges.
Operation
Siphon Feed Gun
fig.3
Gravity Feed
Gun (HVLP)
Air Cap
Assembly
Paint Cup
Long Stem Support
Paint Cup
Siphon Feed Gun
Short Stem Support
Trigger Lock
Pressure Feed Gun
Paint Cup
Note:
Only one gun & one cup shown for clarity.
G375 will clean two guns & two cups in each tank
simultaneously.
Cup Holder
Page 6 of 14
