Installation – Bath Filler & Bath Shower Mixer
1.
Handle Assembly
x2
2.
Shroud
x2
3.
Valve
x2
4.
‘O’ Ring
x2
5.
Backnut & Washer
x2
6.
Wall Bracket*
x1
7.
Handset*
x1
8.
Cradle Assembly*
x1
9.
Diverter Lever*
x1
10.
Diverter Mechanism*
x1
11.
1.5m Hose*
x1
12.
Diverter Shuttle*
x1
1. Check all components are present and
correct before arranging installation.
2. Fit the mixer body to the bath using the
3.
4.
5.
6.
7.
1
2
3
4
5
7
8
9
10
11
12
6
fixing kit provided. Ensure that the ‘O’ rings are in place between the tap body and the bath in
order to create a water tight seal.
Secure into place by fitting the backnut and washer (5) from the underside of the bath.
BATH SHOWER MIXER ONLY:
Fit the cradle assembly (8) to the rear of the mixer body and
attach the hose (11) to both the cradle and the handset (7).
NOTE
: Ensure that the washers are
used when connecting the hose, handset and cradle.
Connect the hot and cold supplies.
Fully open the mixer letting it run for a few minutes, check all joints and connections for leaks.
BATH SHOWER MIXER ONLY:
To fit the wall bracket, position ensuring that the handset will
reach it comfortably. Mark out and drill holes to suit the fixings (not shown) then screw the back
part of the bracket to the wall, and assemble the rest of the components.
* Bath Shower Mixer Only
06
