General Cleaning
Heritage products are made from premium materials, with hand polishing, PVD, EPD and
electroplated finishes.
Your product should be regularly cleaned with warm water, a mild pH-neutral liquid soap, and
polished with a soft cloth. Any residues from soap, toiletries etc. should be rinsed off straight
after use.
Household bleaches and cleaners contain harsh chemicals and may damage the surface finish.
Avoid using abrasive cloths, scouring pads, scrub sponges, steel wool or anything similar.
Some surfaces such as nickel and pewter may be affected by the dye found in some cloths,
so it is also important to avoid leaving cloths on surfaces.
Maintenance
09
If your fitting begins to leak the following should be carried out;
Isolate both hot and cold water supplies to the tap by either:
•
Turning the water supply off at the mains stopcock or
•
Turning off the isolation valves to the tap.
1. Unscrew the indices, to reveal the screw and washer and proceed
to remove these with a suitable screwdriver.
2. Remove the handle and unscrew the shroud.
3. Using a suitable spanner remove the valve. Take care to not
damage the plated finish on the valve stems.
4. Replace the valves. Please visit www.heritagebathrooms.com in
order to find spare parts for this product.
5. Place the valve into the tap body, ensuring the O-Ring is in the
required position, and tighten the valve fully using a suitable
spanner.
6. Re-connect the shroud, handle and all other components.
7. Turn on water supply and check for leaks.
8. Contact our helpline should the problem persist.
Valve
Handle
Shroud
O-Ring
Indice
Screw & Washer
Replacing the Valves
