MY22H03 - 32_1.0_04.10.2021
184
Maintenance
8.5.8.5 eightpins H01 seat post
Only applies to pedelecs with this equipment
Removing the seat post
1
Use a 5 mm hex spanner to unscrew the
Postpin axle.
Figure 204: Undoing the seat post
Detach Bowden cable from the on-bar remote
control on the seat post.
Detach the operating lever from the handlebars
in the case of under-bar-remote control on the
seat post. Activate operating lever. Hold
Bowden cable fastener and pull or tilt forwards.
.
Figure 205: Unfastening the remote control
2
Pull seat post slowly out of the frame.
Figure 206: Removing the seat post
3
Pull out the special end cap for the outer sleeve
from the bracket.
4
Detach the Bowden cable head from the
hydraulic activation lever bracket.
5
If necessary, operate the lever by hand to
make more space for detaching it.
Figure 207: Removing the Bowden cable
Removing the outer sleeve and slide bushing
1
Use a 3 mm hex spanner to remove
attachment screw on the outer sleeve.
2
Detach outer sleeve by pulling upwards with
your hand.
3
Pull slide bushing tube out of the seat tube.
Figure 208: Removing the outer sleeve and slide bushing
Caring for the outer sleeve
1
Push the blue wiper towards the edge.
2
Detach the seal lip ring.
Figure 209: Detaching the seal lip ring
3
Detach spring washer or outer sealing ring.
Figure 210: Removed spring washer
