Pavilion Marquee Instruction Manual www.herculesgazebo.co.nz [email protected] 0800 810 910
10.
Now it is time to install the remaining legs to the corner
fittings. And attach the base plate to each leg with the holes
facing the interior of the marquee.
11. Ratchet assemblies: Fasten the loop strap to each corner
through the two steel D rings on the roof top. Make sure the
legs are straight then secure each base plate by driving
anchoring pins into the hole of the base plate or driving pins
into the ground as deep as it can. Tension ratchets and ropes
until firm.
12. Sidewall Setup Instructions (This step is optional)
The sidewalls are designed to hang around the outside of the
legs with the ratchet rope on the exterior of the sidewalls.
a. Hang each sidewall by buckling the straps on the top of the
side wall around the spreader bar that runs around the
perimeter of the marquee. Each sidewall will cover the distance
between two legs. Loosen the roof top tension if it is difficult to
get the straps around the spreader bar.
b. Tighten the hanging straps so the sidewall is hanging at the
appropriate height or fit with the ground surface the tent is
sitting on. Tuck the ends of each sidewall between the ratchet
assembly and the marquee leg. Make sure the sidewall is
centered between the two legs.
DISMANTLING INSTRUCTIONS
E
Use the above setup instructions
but start at step 11 and work
back to step 2.
