Heras HGD230, User Manual

Page: 88 / 146

EN – Translation of the original user manual - 2.1 | 2019 88
• The display returns to the menu. By activating the menu again, multiple
hand transmitters can be programmed.
• After activating the menu, if the program does not recognize a valid code
within twenty seconds the display returns to the menu.
•
Check the number of transmitters stored by means of the menu option
"Active transmitters".
•
Exit the menu and check the key functions that have been taught in
"Automatic mode".
7.20.3 Teaching hand transmitter buttons
If the functions that are programmed as standard for the hand transmitter OPEN,
CLOSE, STOP are inadequate, another four functions can be programmed. The
individual buttons can be programmed using the menu below.
3 Prog.But OPEN Program OPEN function
4 Prog.But CLOSE Program CLOSE function
5 Prog.Part.OPEN Program PART OPEN function
6 Prog.But Toggle Program Toggle function
OPEN – STOP – CLOSE - STOP
The display shows the function that must be learned in the upper line after
selection. Now the operator has 20 seconds to press the desired button on the
remote control.
A separate storage location is occupied for each individual key function.
The received coding of the transmitter with the special pressed key is stored as a
comparison value in the memory of the controller. The display shows the
numerical value of the received radio signal and the memory space on which this
transmitter was stored for 2 seconds.
RF#: xxxxxxxxxxx
Pos.: p ...
The display then returns to the menu. By activating this menu item again, several
channels can be learned in succession.