Heras HGD230, User Manual

Page: 14 / 146

EN – Translation of the original user manual - 2.1 | 2019 14
• Closing the gate infill openings in any way, such as by means of banners,
advertising signs etc, is not allowed as this may negatively affect the safe
operation of the gate.
•
All alterations or extensions to the gate must be carried out by qualified
personnel using parts which the manufacturer has defined as suitable for
such alterations or extensions. Any failure to comply with these
instructions will be considered as non-compliant behavior and will
invalidate the manufacturer's guarantee, as a result of which the risk
entirely transfers to the user.
•
For a double sliding gate, it is strictly forbidden to remove the central
slam support (mounted on the floor in the opening). This is important for
the stability of the gate when closed.
•
Improper usage or servicing or ignoring the operating instructions can be
a source of danger for persons, and/or result in material damage.
•
If the meaning of any part of these installation and operating instructions
is not clear, then please contact your supplier before you use the
equipment.
•
This manual must always be available at the operating location of the
control /gate. This manual must be read thoroughly and applied by all
persons who are in charge of the operation, maintenance and restoration
of the controls.
The HMD230 is a frequency converter. Since dangerous live voltage
may still be present after switching off the HMD230, you must
observe a 3 to 5 minute waiting time to make sure that all power
has discharged. Working on a live frequency converter PCB involves
a risk of fatal injury!
2.4 SAFETY PROVISIONS EMPLOYED
•
To protect people and goods from injury or damage, the gate is fitted with
safety provisions including safety edges and/or photocells.
These serve as emergency provisions that immediately stop and reverse
the movement of the gate. It is forbidden to use these provisions to stop
the gate normally.
•
For a gate with hold-to-run control, the above-mentioned safety
provisions are not necessary and will therefore not be standard
provisions.
With this type of operation, the gate stops immediately as soon as the
switch is released.